Accessories
Download our Accessories Brochure
10 Ton Jack Stands
WEIGHT: 10 ton capacity
USE: To support raised trucks and buses. The support stand is designed to be used in sets of 4, 6 or 8 and must be placed under a level raised vehicle at the point designated by the vehicle manufacturer.
FEATURES:
- ergonomic design
- easily moved and placed under a vehicle
- easy to adjust with a spring-assisted center tube
- U shaped saddle
- adjustment pin is secured to the stand to prevent loss.
12 Ton Jack Stands
WEIGHT: 12 ton capacity
USE: To support raised trucks and buses. The support stand is designed to be used in sets of 4, 6 or 8 and must be placed under a level raised vehicle at the point designated by the vehicle manufacturer.
FEATURES:
- ergonomic design
- easily moved and placed under a vehicle
- easy to adjust with a spring-assisted center tube
- laminated hardwood top.
- U shaped saddle.
- checker plate top (optional no cost).
- adjustment pin is secured to the stand to prevent loss.
- 2 ¼ ACME screw provides 6 inches fine adjustment.
- heavy duty construction.
18 Ton Jack Stands
WEIGHT: 18 ton capacity
USE: To support raised trucks and buses. The support stand is designed to be used in sets of 4, 6 or 8 and must be placed under a level raised vehicle at the point designated by the vehicle manufacturer.
FEATURES:
- ergonomic design
- easily moved and placed under a vehicle
- easy to adjust with a spring-assisted center tube
- laminated hardwood top.
- U shaped saddle.
- checker plate top (optional no cost).
- adjustment pin is secured to the stand to prevent loss.
- 2 ¼ ACME screw provides 6 inches fine adjustment.
- heavy duty construction.
Transmission Jack
WEIGHT: 3500 lbs
USE: For removal and installation of transmissions, differentials and other components. Ideal for buses, trucks and construction equipment.
FEATURES:
- ergonomic design
- fast and easy operation with an air driven hydraulic pump.
- air filter-regulator-lubricator included.
- manual pump provides precise positioning.
- large «X» design base for stability and easy access.
- fully adjustable universal table comes with two ratchet tie-down straps to secure the load to the jack. Three table sizes available.
- variety of table adaptors available for specific transmissions and differentials.
- large heavy-duty ball bearing wheels.
- locks on rear wheels
SPECIFICATIONS:
Diameter wheels: 8 inches front. 6 inches rear, with brake.
Table tilt: 12 degrees front to back. 12 degrees side to side.
Capacity: 3500 lbs.
Minimum height: 35 inches.
Maximum height: 74 inches.
Wheel Dolly
WEIGHT: 1000 lb capacity
USE: For removal and installation of single and dual wheels on raised buses and trucks. Ideal for working with brakes.
FEATURES:
- ergonomic design
- open center design allows full access to the wheel mounting hardware
- fast and easy operation with an air driven hydraulic pump
- lifting fork tilts up to 10 degrees and down 4 degrees, in order to match the wheel to the wheel axle
- for precise control, a hand pump operates the tilt on the lifting forks.
- handling is made easy by means of two full length handles.
- heavy duty ball bearing wheels.
- safety cam-buckle strap provided to secure tires and wheels to the dolly.
- counterbalanced version is available to use with parallelogram lifts.
SPECIFICATIONS:
Lifting speed: 52 inches per minute.
Lifting fork tilt adjustment: 10 degrees above horizontal. 4 degrees below horizontal.
Operating air pressure: 100 to 120 PSI.
Wheel diameter: 5 inches with ball bearings.
